Application Acceleration
Reply
Contributor
incman
Posts: 12
Registered: ‎06-21-2010
0

WXos - ISM and SNMP

Hi

 

Having some issues with SNMP on the ISM modules for the J's. The ISM not responding to SNMP gets, it pops back a ICMP port unreachable and no traps are sent either. Syslog works like a charm, and I am running :-

 

Software version: 5.7.5.0
Model No.: ISM-200-WXC - v1.0

 

Config is:-

 

config snmp set snmp on
config snmp set read-community "xxxxxxxxxxxxxx"
config snmp set write-community "xxxxxxxxxxxxxx"
config snmp set trap on
config snmp traps add destination 10.xx.xx.xx community "xxxxxxxxxxxxxxxxxxx"
config snmp set auth-failure-trap off

 

Looks simple enough?

 

thanks

Ivan

Super Contributor
imirza
Posts: 88
Registered: ‎12-14-2009
0

Re: WXos - ISM and SNMP

Ivan -

 

Sorry for the delay. This one just slipped through my radar.

 

SNMP walk is not supported on the ISM as they are not separate entities. You will have to do the MIB walk on the J-Series router, which works perfectly fine.

It is kind of confusing why the SNMP option is even there in the GUI.

 

Let me know if that helps.

 

Thanks

Iqbal Mirza

SRX Global JTAC

JNCIE-SEC#68, JNCIS-M, CCNP
_______________________________________
"Accepted Solution" = If the solutions works for you.
"Accepted Solution+Kudos" = If you really think I earned it.
Contributor
incman
Posts: 12
Registered: ‎06-21-2010
0

Re: WXos - ISM and SNMP

Hi Iqbal

 

Ok, so to recap you walk the Jseries with the wxc MIBs? You interrogate the Jseries for WXC snmp info?

 

thanks

Ivan

Super Contributor
imirza
Posts: 88
Registered: ‎12-14-2009
0

Re: WXos - ISM and SNMP

Yes. That is correct.

Iqbal Mirza

SRX Global JTAC

JNCIE-SEC#68, JNCIS-M, CCNP
_______________________________________
"Accepted Solution" = If the solutions works for you.
"Accepted Solution+Kudos" = If you really think I earned it.
Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.