Routing from router cisco to active/active cluster ssg

[Nonick]

We have an A/A cluster (2 firewalls SSG520 ) with VSD0 and 1 and we have 2 red interface ( red1 and red1:1 ). Untrust zone is connected to our remote site and trust zone is local. In trust zone we have router cisco is gateway for my local, that we must set route to my remote site cross firewall in gateway. There're 2 red interfaces, how can i define next hop for my route?

[MattS · Accepted solution]

Hello, this forum is for the DX appliance

(http://www.juniper.net/products_and_services/application_acceleration/data_center_acceleration/dx_ap...),

 I believe your query would be best answered by the Firewall forum at http://forums.juniper.net/jnet/board?board.id=Firewalls

Message Edited by MattS on 08-08-2008 11:09 AM

[Nonick]

oh sorry! thanks for your advise!