Does EX8200 support virtual chassis or SMLT type configuration [ Edited ]

[hazeen]

Hi,

I wanted to know the following and searching juniper site for info did not yield any result.

1. Does Juniper EX8200 support virtual chassis?

2. Can i dual home an edge switch to two EX8200 core switches (without using STP) using something similar to SMLT on found on nortel?

3. If i am teaming nics on server to two EX8200 core switch, is there any special configuration required on the core.

4. Does Juniper EX8200 support Multi Chassis LAG?

Regards,
Haze

[Loup2 · Accepted solution]

My answers above AFAIK

1. Does Juniper EX8200 support virtual chassis?

- No, this is planned and we are all waiting for this

2. Can i dual home an edge switch to two EX8200 core switches (without using STP) using something similar to SMLT on found on nortel?

- No, the answer from juniper is to use RTG (Redundant trunk group) instead (port backup or link backup on others vendors, Flexlink on C..)

3. If i am teaming nics on server to two EX8200 core switch, is there any special configuration required on the core.

- You can't make an aggregation (ie LACP) on two different Chassis

4. Does Juniper EX8200 support Multi Chassis LAG?

No.

Yes we are all waiting for this

The answer today on Juniper switches is 4200 boxes but not the chassis

Hope this will help you

[joezhou]

hi loup2,

does juniper plan to support Multi Chassis LAG on EX4200(non-VC)? when?

thks

joe

[joezhou]

RTG (Redundant trunk group) can only support L2 switching port, how to backup a L3 port( in case i dont want to use

any dynamic routing protocols)?

[Loup2]

I don't think so (nothing as Split MLT)

[Loup2]

You can use static routes with different metrics

That's the way to do what you want at Layer 3 without routing protocol 

[hazeen]

Hi,

Just to update this topic....looks like juniper is now support virtual chassis on EX8200 but it requires an additional appliance - the XRE200 Routing Engine.

Regards,

Haze

[JNPRdhanks]

The EX8200 supports virtual-chassis.

http://www.juniper.net/techpubs/en_US/junos/topics/concept/virtual-chassis-ex8200-overview.html

[computingbee]

So now that Juniper supports VCP between two 8200 switches. Is it possible to create an LACP or static LAG from an edge swtich to the two chassis participating in VCP? I am assuming that answer is yes but looking for a confirmation.

Thanks

[jozef.klacko]

hi,
which static bonding mode will you choose for Linux or OpenSolaris with 8200VC?