Ethernet Switching
Reply
Juniper Employee
cfrizziero
Posts: 25
Registered: ‎01-06-2010
0

Preprovisioned configuration

Hi Folks,

 

My customer has already setted up a VC with 2 memebers in a defult configuration fashion.

Now they want to configure the VC in a pre-provisioned manner, and the question is: can we simply configure in [edit virtual-chassis] or do we need to reboot the VC too after the commit?

Thanks

 

Cristian

Super Contributor
nikolay.semov
Posts: 170
Registered: ‎03-15-2012
0

Re: Preprovisioned configuration

Assuming you're talking about EX4200 here.

 

This shouldn't require reboot, but it might cause RE to jump to another switch. I would still do this within a maintenance window, just in case.

 

Triple-check serial numbers you put in the pre-provisioned configuration. Also, you may want enable split-brain detection after the 3rd switch is added, in case it had been previously disabled. GRES is also enabled, right?

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.