Switching

last person joined: yesterday 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.

  • 1.  Redundant Trunk Group on EX and J series and LACP with Cisco router

    Posted 07-17-2017 21:11
      |   view attached

    Hi,
    We are going to improve our current network by adding additional switch, router and firewall in order to eliminate single point of failure. Below is the network topology (also as attached), but I am not quite sure on the design especially on the redundant trunk group between routers and switches. Appreciate if you guys could give some comments on it. Secondly, does J-Series router support LACP? Our internet router is using Cisco 2960 and will connect to 2xJ6350 routers using LACP.

     

    HA1.jpg

     

     



  • 2.  RE: Redundant Trunk Group on EX and J series and LACP with Cisco router
    Best Answer

    Posted 07-22-2017 02:49

    Hi Zulcap 

     

    May be you can try and make the EX3200 as 2 member VC and enable no split detection, so that atleast one member stays UP in case of any issue. This will eliminate the need for RTG. 

     

    Yes J-Series router supports LACP. Refer page 6 of https://kb.juniper.net/library/CUSTOMERSERVICE/technotes/3500133-EN.pdf

     

    Thanks

    Arul