I am trying to add an outer VLAN to traffic that egresses on an interface on an EX4550. The source of the traffic is ingressing on a .1q port that has other VLANs configured that need to egress on ports. For this reason I can not configure the ingress port as a .1ad access port. I am trying to push a tag using 'input-vlan-map'/'output-vlan-map' but it appears to not be available as a command at the [edit interfaces ge-0/0/31 unit 0] stanza despite being mentioned in various documentation. I am running Junos 12.3R5.7.
{master:0}[edit interfaces ge-0/0/31 unit 0]
admin@agg-sw2.doc1# set ?
Possible completions:
> accept-source-mac Remote media access control address to/from which to accept traffic
accounting-profile Accounting profile name
+ apply-groups Groups from which to inherit configuration data
+ apply-groups-except Don't inherit configuration data from these groups
> arp-resp Knob to control ARP response on the interface, default is restricted
bandwidth Logical unit bandwidth (informational only)
description Text description of interface
disable Disable this logical interface
encapsulation Logical link-layer encapsulation
> family Protocol family
> interface-shared-with Specify which PSD owns this logical interface
no-traps Don't enable SNMP notifications on state changes
> proxy-arp Enable proxy ARP on the interface, default is unrestricted
swap-by-poppush Pop original vlan tag and then push a new vlan tag
traps Enable SNMP notifications on state changes
vlan-id Virtual LAN identifier value for 802.1q VLAN tags (0..4094)