Hi,
I am trying to configure 2x 10GE XFP on two EX4200 Switches. These uplinks would not be configured as Virtual but as trunks to Cisco 6509's.
After the install and reboot, the switches do show FPC 0 PIC 1 online, but I have been unable to find a configuration guide for these.
These interfaces do not show up in operational mode (show interface terse) but ge-0/1/0 -3 are show in config mode (show interface ?)
Any help would be highly appreciated.
admin@jswitch> show chassis pic fpc-slot 0 pic-slot 1
FPC slot 0, PIC slot 1 information:
Type 2x 10GE XFP
State Online
PIC version 2.4
Uptime 5 hours, 19 minutes, 55 seconds
admin@switch> show interfaces terse
Interface Admin Link Proto Local Remote
ge-0/0/0 up down
ge-0/0/0.0 up down eth-switch
.
.
ge-0/0/47 up down
ge-0/0/47.0 up down eth-switch
vcp-0 up down
vcp-0.32768 up down
vcp-1 up down
vcp-1.32768 up down
bme0 up up
bme0.32768 up up inet 128.0.0.1/2
128.0.0.16/2
128.0.0.32/2
tnp 0x10
dsc up up
gre up up
ipip up up
lo0 up up
lsi up up
me0 up up
me0.0 up up inet
mtun up up
pimd up up
pime up up
tap up up
vlan up up
vlan.0 up down inet
vme up down
admin@switch# show interfaces ?
Possible completions:
<[Enter]> Execute this command
<interface-name> Interface name
+ apply-groups Groups from which to inherit configuration data
+ apply-groups-except Don't inherit configuration data from these groups
ge-0/0/0 Interface name
.
.
ge-0/0/47 Interface name
ge-0/1/0 Interface name
ge-0/1/1 Interface name
ge-0/1/2 Interface name
ge-0/1/3 Interface name
> interface-range Interface ranges configuration
me0 MGMT INTERFACE - DO NOT DELETE
> traceoptions Interface trace options
vlan Interface name
| Pipe through a command