Junos and Junosphere
Blogs
Discussion Forums
Programs & Events
turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Reply
Topic Options
asad747
Contributor
asad747
Posts: 19
Registered: ‎07-21-2009
0

Multiple hosts (mac addresses) across L2circuit

Options

‎01-11-2012 03:27 AM

Dear friends,

 

I have a topology (image attached) where i have a Point-to-point L2circuit connection between PE routers. However customer is using Switches at both the Ends and wants to use same IP Address scheme on both sides.


Is it a workable solution?? is there any limit of mac-address (hosts) learned in l2circuit???     

 

 

Attachment qinq-l2circuit.jpg ‏64 KB
Message 1 of 2 (289 Views)
 
Reply
Distinguished Expert
Distinguished Expert
pk
Posts: 676
Registered: ‎10-09-2008
0

Re: Multiple hosts (mac addresses) across L2circuit

Options

‎01-12-2012 06:06 AM

Hi

 

L2circuit is not learning addresses (unlike VPLS). It just passes frames from one side to the other.

 

So you should have no problem with your setup.

Best Regards,
Peter (PK)

Juniper Ambassador, Juniper Networks Certified Instructor,
JNCIE-SEC, JNCIP-(M,ENT) JNCIS-(SA,AC,FWV) JNCIA-(IDP,WX)
[Juniper Authorized Education & Support in Russia]
Message 2 of 2 (258 Views)
 
Reply
Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.