Setting up radius server auth on a J-series no routing-instance option??

[juniper321]

trying to setup radius authentication on a J-series running 10.2.R4.8 code and i don't see an option to define a routing-instance

admin@router1# set system radius-server 1.1.1.1 ?
Possible completions:
  <[Enter]>            Execute this command
  accounting-port      RADIUS server accounting port number (1..65535)
+ apply-groups         Groups from which to inherit configuration data
+ apply-groups-except  Don't inherit configuration data from these groups
  port                 RADIUS server authentication port number (1..65535)
  retry                Retry attempts (1..10)
  secret               Shared secret with the RADIUS server
  source-address       Use specified address as source address
  timeout              Request timeout period (1..90 seconds)
  |                    Pipe through a command
[edit]

what gives?

[Visitor]

Hi ,

There is no direct way to define radius server referring VR , but for workaround you can refer kb http://kb.juniper.net/InfoCenter/index?page=content&id=KB21085&cat=&actp=LIST

Hope this helps.

Regards,
Visitor

--------------------------------------------------​--------------------------------------------------​---
If this post was helpful, please mark this post as an "Accepted Solution".Kudos are always appreciated!

[juniper321]

hmm..i've seen some configs that have

set system radius-server x.x.x.x routing-instance routing-instance-name

i'll give it a shot

[juniper321]

that doc didn't work for me..oh well..