Junos
Reply
Contributor
asad747
Posts: 19
Registered: ‎07-21-2009
0

Multiple hosts (mac addresses) across L2circuit

Dear friends,

 

I have a topology (image attached) where i have a Point-to-point L2circuit connection between PE routers. However customer is using Switches at both the Ends and wants to use same IP Address scheme on both sides.


Is it a workable solution?? is there any limit of mac-address (hosts) learned in l2circuit???     

 

 

Distinguished Expert
Distinguished Expert
pk
Posts: 806
Registered: ‎10-09-2008
0

Re: Multiple hosts (mac addresses) across L2circuit

Hi

 

L2circuit is not learning addresses (unlike VPLS). It just passes frames from one side to the other.

 

So you should have no problem with your setup.

Best Regards,
Petr (PK)

Juniper Ambassador, Juniper Networks Certified Instructor,
JNCIE-SEC #98, JNCIE-ENT #393, JNCIE-SP #2253
[Juniper Authorized Education & Support in Russia]
Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.