Junos OS

Dear all,

I've had following error on a EX4200-24t:.  (It is not a member of a Virtual Chassis.)

rend_dlinit: not a proper library: /usr/lib/render//libvccpd-render.so: Cannot open "/usr/lib/render
//libvccpd-render.so"
{linecard:0}

There was no routing possible (It's normal because the switch got in linecard-mode) How this is possible, I don't know. Software version is 10.3

I've recoverd the switch by reinstalling the software through an USB-stick.  Does anyone know why the switch gave me this problem???

Thanks in advance!

Best regards,

Lars Aerts

Hi Lars Aerts,

Requirements:  You need, Junos OS Release 11.1 or later to have an RVI to route traffic between two VLANs on the same switch.

Thanks,

Jay

I don't get your answer I think...

Do you mean the following:

When you have the following thing configured on the ex4200.  It won't route that traffic when you have soft-version 10.3???

Set interfaces vlan unit 100 family inet address 192.168.0.1/24

Set interfaces vlan unit 200 family inet address 192.168.1.1/24

Set vlans test vlan-id 100

set vlans test interface ge-0/0/0

Set vlans test1 vlan-id 200

set vlans test interface ge-0/0/1

RVI is a basic feature of the EX switch line since the initial release.  From what you show above it appears that the Junos installation is corrupt.

Maybe the recover from a failed software installation procedure will help.

http://kb.juniper.net/InfoCenter/index?page=content&id=KB10914

Be sure to save out a copy of your current configuration in case this gets lost in the processes.

Rescue config will put a copy on the device you can pull from.

system configuration rescue save

KB12022 shows how to put a copy to a usb disk

http://kb.juniper.net/InfoCenter/index?page=content&id=KB12022

Thanks for the information