Management
Showing results for 
Search instead for 
Do you mean 
Reply
New User
Posts: 1
Registered: ‎04-19-2017
0 Kudos

Recover configuration pre-virtual chassis

I set up a virtual chassis on a couple of switches unintentionally and didn't assign the proper member as master. Every converted to the new master's settings by default. I see literature on how to restore to factory default settings once you remove the member from the VC. But what is done to the rollback queue once a member is added to a virtual chassis? Does it count as one rollback slot? And everytime there is a change committed would this go in the queue of the member as well if taken out? Or could I just use a rollback 1 and go back to normal? There is nothing critical in this setup that is driving this. I just couldn't find a printed answer to this.

 

Thanks!

Highlighted
Distinguished Expert
Posts: 4,873
Registered: ‎03-30-2009
0 Kudos

Re: Recover configuration pre-virtual chassis

I am not sure I follow the scenario but I think you are saying:

 

Connected two switches

made configuration changes to create a virtual chassis

Now you want to become two stand alone switches again

 

I have not done this before.  But based on other experiences with the EX, I think you will need to follow the Virtual chassis removal procedure in the kb and not simply rollback and reboot.

 

 

Steve Puluka BSEET
Juniper Ambassador
Senior IP Engineer - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
JNCIA-Junos JNCIS-SEC JNCIP-SEC JNCSP-SEC
JNCIS-FWV
JNCDA JNCDS-DC JNCDS-SEC
JNCIS-SP
ACE PanOS 6 ACE PanOS 7
http://puluka.com/home