Routing

Hello,

Is there concept of  "adjacency table" in Juniper.

Any command for this ?

I am using MX960 platform with L3VPN service.

Regards # Mahesh

Hi,

could you explain what do you mean and what you are calling adjacency table?

If you want to check the routes in your VRF you can execute the command show route table VRF-NAME

--
If this post solves your problem, please mark this post as "Accepted Solution".
Kudos are appreciated

Sorry for confusion.

I was comparing with Cisco where L3 lookup is performed in CEF table and for L2 lookup "adjacency table" is used.

Let me show you example from one of my cisco device to have better understanding.

xxxx#sh adjacency GigabitEthernet4/0/0 det
Protocol Interface                 Address
IP       GigabitEthernet4/0/0      x.x.x.x(15)
                                   5983 packets, 427061 bytes
                                   epoch 2
                                   sourced in sev-epoch 72
                                   Encap length 14
                                   00046D7D141A00270DCA23800800  <<< src-mac / dst-mac / ethertype
                                   L2 destination address byte offset 0
                                   L2 destination address byte length 6
                                   Link-type after encap: ip
                                   ARP 

Regards

Mahesh

Hi,

Maybe you are looking for show route forwarding-table