Routing
Reply
New User
Thiaguets
Posts: 1
Registered: ‎08-06-2008
0

JUNOSe Load Balance

Hi All. I have an ERX1440 with 4 Gig interfaces, using ECMP. What are the correct commands I can use to determine if load balancing is really happening? I'm already using "show interfaces". I'd like something more advance...

Thank you.

Regular Visitor
dlockuan
Posts: 8
Registered: ‎07-15-2008
0

Re: JUNOSe Load Balance

Hi Thiaguets,

 

If you want to check the ECMP, you could use the next commands:

 

show ip route 0.0.0.0 (I'm imaging that you have that links to your default router)

show int giga x/y (To check in the part of input and output rates. In all interfaces should be with the same rate)

 

if you want more information, search into Techpubs (www.juniper.net/techpubs), here there are more information about the JunoSE and example of configurations.

 

Best regards,

 

DLA. 

Juniper Employee
DaveDugal
Posts: 2
Registered: ‎01-08-2009
0

Re: JUNOSe Load Balance

Alternately, if you want to look at the actual egress data rate, you can enable a 'rate' in the default QoS statistics profile as follows:

 

statistics-profile default

  rate 30

 

and then use the 'show egress rates interface g1/0', 'show egress rates interface g2/0', etc. to view the real-time egress rates for each IP interface.

 

- Dave

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.