Routing
Showing results for 
Search instead for 
Do you mean 
Reply
Trusted Contributor
Posts: 908
Registered: ‎08-10-2010
0 Kudos

Not have output when connect on Console port RE0?

Hi all,

 

 

i facing weird beahavour. Suddenly when i console to RE0 then not output display. But if i change to console on RE1 then have output. It's not have issue to access RE0 from RE1. I know it can be resolve if i reboot RE0 but i try not to reboot RE0 because it production unit.

 

Appreciate any feedback if someone has exprience facing this issue.

 

 

Thanks

Distinguished Expert
Posts: 5,111
Registered: ‎03-30-2009
0 Kudos

Re: Not have output when connect on Console port RE0?

Is re0 still master?

Can you ssh to management?

Any logging that seems related?

 

Try logging into re0 from the re1 connection

 

request routing-engine login re0

Steve Puluka BSEET
Juniper Ambassador
Senior IP Engineer - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
JNCIA-Junos JNCIS-SEC JNCIP-SEC JNCSP-SEC
JNCIS-FWV
JNCDA JNCDS-DC JNCDS-SEC
JNCIS-SP
ACE PanOS 6 ACE PanOS 7
http://puluka.com/home
Trusted Contributor
Posts: 908
Registered: ‎08-10-2010
0 Kudos

Re: Not have output when connect on Console port RE0?

Hi Spuluka,

 

 

It no issue to login RE0 from RE1. RE0 is master. The issue was when i connect direct console cable into console port on RE0.

 

 

Thanks

Highlighted
Super Contributor
Posts: 68
Registered: ‎06-21-2017
0 Kudos

Re: Not have output when connect on Console port RE0?

Hi Kronicklez,

 

This seems to be an issue with the console port which can be resolved only via reboot or reseat. I don't think there is any other way to get the console working in this case. You can swithover the RE and then try to check the console and still it doesn't respond, reboot the routing engine.  If reboot also doesn't work you may have to replace the RE.

 

 

Regards,

Rahul

Please mark my solution as accepted if it helped.