Hi Guys,
I setup a service provider lab in unetlab using vmx version 14.1R1.10 .
The IGP for running the RSVP and MPLS between P and PE routers is using OSPF.
PE and PE is using Ibgp.
Also there is tunnel configured between PE and PE.
This seems like simple setup.
But the PE can only ping the CE that is connected to it not the remote CE.
One CE is connected to PE using static and another is using EBGP.
Hope you guys can share some inputs.
Thank you.
VMX2 show cmd output.
root> show route table bgp.l3vpn.0
bgp.l3vpn.0: 2 destinations, 2 routes (2 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
65500:1:10.0.31.0/30
*[BGP/170] 01:11:11, localpref 100, from 192.168.16.1
AS path: I, validation-state: unverified
> to 10.0.0.2 via ge-0/0/0.0, label-switched-path RoutervMX2-PE-to-RoutervMX1-PE
65500:1:192.168.14.1/32
*[BGP/170] 01:18:04, localpref 100, from 192.168.16.1
AS path: 65530 I, validation-state: unverified
> to 10.0.0.2 via ge-0/0/0.0, label-switched-path RoutervMX2-PE-to-RoutervMX1-PE
root> show bgp summary
Groups: 1 Peers: 1 Down peers: 0
Table Tot Paths Act Paths Suppressed History Damp State Pending
bgp.l3vpn.0
2 2 0 0 0 0
Peer AS InPkt OutPkt OutQ Flaps Last Up/Dwn State|#Active/Received/Accepted/Damped...
192.168.16.1 65500 224 228 0 0 1:37:21 Establ
bgp.l3vpn.0: 2/2/2/0
VPN2.inet.0: 2/2/2/0
root> show mpls lsp
Ingress LSP: 1 sessions
To From State Rt P ActivePath LSPname
192.168.16.1 192.168.19.1 Up 0 * RoutervMX2-PE-to-RoutervMX1-PE
Total 1 displayed, Up 1, Down 0
Egress LSP: 1 sessions
To From State Rt Style Labelin Labelout LSPname
192.168.19.1 192.168.16.1 Up 0 1 FF 3 - RoutervMX3-PE-to-RoutevMX2-PE
Total 1 displayed, Up 1, Down 0
Transit LSP: 0 sessions
Total 0 displayed, Up 0, Down 0
root> show ospf neighbor
Address Interface State ID Pri Dead
10.0.0.2 ge-0/0/0.0 Full 192.168.17.1 128 33
Attached is the config of each VMX and show logs as well.
Below is the diagram.