Routing
Reply
Contributor
ggglabs
Posts: 20
Registered: ‎12-15-2011
0

logical-systems and discard (dsc) interface

Hi

 

I'm trying to set up dsc interfaces in logical systems. It seems only one logical system is able to use the discard interface. What am I doing wrong or is this a real restriction?

 

Only unit 0 is supported and same unit cannot be configured on several logical-systems. So this does not work:

 

logical-systems R1 interfaces dsc.0 family inet address ....

logical-systems R2 interfaces dsc.0 family inet address ....

 

commit error:

[edit logical-systems R2 interfaces dsc]
  'unit 0'
    Interface dsc.0 is included in more than one logical systems R2 (current) and R1 (prev)
error: configuration check-out failed

 

 

With loopback interface this would work, but with dsc it does not:

 

logical-systems R1 interfaces dsc.0 family inet address ....

logical-systems R2 interfaces dsc.1 family inet address ....

 

commit error:

[edit logical-systems R2 interfaces dsc]
  'unit 1'
    Only unit 0 is valid for this interface
error: configuration check-out failed

M7i and Junos 10.4R8.5

 

Thanks

Juniper Employee
jstar
Posts: 22
Registered: ‎04-28-2008
0

Re: logical-systems and discard (dsc) interface

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.