SRX Services Gateway
Reply
Contributor
after1
Posts: 69
Registered: ‎06-04-2010
0

Configure trunk interface between srx and Cisco

[ Edited ]

I have one SRX240 and one cisco 6509 switch

 

Cisco6509 -------- SRX240

 

I have configured the Cisco but I don't know how to configure the srx. Could some one please show me how to configure on the srx?

 

Here's the cisco config:


interface GigabitEthernet1/1
 description Connect to Juniper SRX240
 switchport
 switchport access vlan 100                  << this is an access port and only vlan 100 is allow to pass through.
 switchport mode access
 switchport nonegotiate

 

Thanks in advance

Contributor
pkcpkc
Posts: 89
Registered: ‎11-10-2010
0

Re: Prolem connecting Srx240 to Cisco switch

what does the show interface ge-3/0/0 detail show ?

 

if you set vlan.1 with an IP, do you have any MAC in the arp table ? (I assume not).

 

If you connect a pc directly to the ge-3/0/0 or ge-2/0/0, can you ping the srx from the pc or pc from the srx ?

Super Contributor
colemtb
Posts: 312
Registered: ‎09-30-2009
0

Re: Configure trunk interface between srx and Cisco

If you don't need layer three just do the following...

 

vlans {
        v100 {
        vlan-id 100;
        interface {
            ge-0/0/0.0;
        }
    }
}

 

This puts the port in vlan v100 with a vlan-id of 100.  If you need layer three termination you can add the

 

interfaces {
    vlan {
        unit 100 {
            family inet {
                address 1.1.1.1/32;
            }
        }
    }
}

 

vlans {
    v100 {
        vlan-id 100;
        interface {
            ge-0/0/0.0;
        }
        l3-interface vlan.100;
    }
}

_________________________________________________________________________________________

 

I also see that vlan with an id of 100 is commonly associated with voice, CME and such...  If that's the case, just do the following...

 

ethernet-switching-options {
    voip {
            interface ge-0/0/0.0 {
            vlan 100;
        }
    }
}

 

vlans {
       v100 {
        vlan-id 100;
    }
}

 

 

 

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.