Hello,
i am trying to set up HA on two SRX210 (using the Junos Software Security Configuration Guide) but it doesn't work at all.Control link is connected between fe-0/0/7 (no other choice) of the boxes and fabric/data between fe-0/0/.
Let's see, what i have done:
Both boxes are running latest JunosES 9.6:
{primary:node0}
root> show system software
node0:
--------------------------------------------------------------------------
Information for junos:
Comment:
JUNOS Software Release [9.6R1.13]
node1:
--------------------------------------------------------------------------
Information for junos:
Comment:
JUNOS Software Release [9.6R1.13]
I started with 2 fresh, factory defaulted boxes and configured the chassis cluster. Set one box node 0 of cluster id 1 and the other node 1 of cluster 1and rebooted them.
Then it shows up like this (this is correct, i assume):
{primary:node0}
root> show chassis cluster status
Cluster ID: 1
Node name Priority Status Preempt Manual failover
Redundancy group: 0 , Failover count: 1
node0 1 primary no no
node1 1 secondary no no
Then i set the root password (which is mandatory now) and changed the priority of redundancy group 0, and after that, it shows up like this:
{primary:node0}
root> show chassis cluster status
Cluster ID: 1
Node name Priority Status Preempt Manual failover
Redundancy group: 0 , Failover count: 1
node0 100 primary no no
node1 50 secondary no no
See lights on fe-[0/2]/0/7 are blinking and on fe-[0/2]/0/6 constantly green.
i check the communication and see, that fabric probes are received (i assume, this is because no fabric interfaces are configured right now).
{primary:node0}
root> show chassis cluster control-plane statistics
Control link statistics:
Heartbeat packets sent: 265
Heartbeat packets received: 237
Fabric link statistics:
Probes sent: 263
Probes received: 0
so, i configured the fab interfaces:
{primary:node0}[edit]
root# set interfaces fab0 fabric-options member-interfaces fe-0/0/6
{primary:node0}[edit]
root# set interfaces fab1 fabric-options member-interfaces fe-2/0/6
after commiting, the led on fe-[0/2]/0/6 starts blinking frequently (looks like traffic is beeing processed now), but still no fabric probes are received:
{primary:node0}
root> show chassis cluster control-plane statistics
Control link statistics:
Heartbeat packets sent: 363
Heartbeat packets received: 335
Fabric link statistics:
Probes sent: 361
Probes received: 0
after a while the node 1 goes down and i see the messages in jsrpd log:
{primary:node0}
root> show log jsrpd
<...snip...>
Sep 16 18:37:03 Successfully sent an snmp-trap due to a failover from secondary
to disabled on RG-0 on cluster 1 node 1 Reason: fabric-link-failure
Sep 16 18:37:03 detected change in RG-0 state for node1
Sep 16 18:37:03 LED color changed from : Green to Red, reason Peer node: node1 i
s disabled
chassis cluster status is now:
{primary:node0}
root> show chassis cluster status
Cluster ID: 1
Node name Priority Status Preempt Manual failover
Redundancy group: 0 , Failover count: 1
node0 100 primary no no
node1 50 disabled no no
There are no additional redundancy groups ore any reths configured. Am i missing something or misconfigured? What is wrong? Would greatly appreciate if someone could help me.
Thanks.