SRX Services Gateway
Blogs
Discussion Forums
Programs & Events
turn on suggestions Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Reply
Topic Options
zerofai
Contributor
zerofai
Posts: 15
Registered: ‎06-02-2011
0

IPv6 source NAT with HE Tunnel

[ Edited ]
Options

‎07-13-2011 09:44 PM - edited ‎07-18-2011 08:16 AM

Hi All, I have a HE tunnel setup on my SRX 210 (11.1 R3) as below: Host A fc00:10::a <> (vlan.0,trust zone) fc00:10::1 -- (ip-0/0/0.0 untrust0 2001:470::2/64 The tunnel is working fine and I can access some IPv6 web on the SRX When I see the traffic flow and it seems return traffic cannot pass back. Did anyone try similar configuration? Please advise. Cheers, Fai

Message 1 of 3 (515 Views)
 
Reply
Trusted Contributor
BuckWeet
Posts: 159
Registered: ‎08-29-2008
0

Re: IPv6 source NAT with HE Tunnel

Options

‎07-15-2011 07:21 PM

http://forums.juniper.net/t5/SRX-Services-Gateway/HE-IPv6-tunnel-with-flow-based-IPv6-in-10-4/td-p/6...

 

Read over that posting.. Probably the issue you're hitting..

Message 2 of 3 (495 Views)
 
Reply
zerofai
Contributor
zerofai
Posts: 15
Registered: ‎06-02-2011
0

Re: IPv6 source NAT with HE Tunnel

Options

‎07-18-2011 08:13 AM

Thanks BuckWeet

 

Actually I have read that post before.

But it seems in my environment I cannot isolate the problem due to the complexty of the setup.

 

Will keep post when issue resolved. Thanks in advise!

 

 

Message 3 of 3 (480 Views)
 
Reply
Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.