Hello gentlemen,
I'm using SRX240 for a while and faced new issue, which I can not understand and explain. Any advice much appreciated.
We have 2 interfaces:
> show configuration interfaces ge-0/0/9
unit 0 {
family ethernet-switching {
port-mode access;
vlan {
members cisco;
}
> show configuration interfaces ge-0/0/15
unit 0 {
description MANAGEMENT;
family ethernet-switching {
port-mode access;
vlan {
members server;
}
And some vlans:
cisco {
description cisco;
vlan-id 5;
l3-interface vlan.3;
}
server {
description "vlan 50";
vlan-id 50;
l3-interface vlan.0;
}
Both interfaces are connected to cisco switch, both ports are in access mode, one in vlan 5 and one in vlan 50.
If we enable only one (any) interface everything is good, but if enable both of them, interface in vlan 50 stops sending anything to the port. It's receiving packets, but not sending anything. On cisco mac address from interface in vlan 50 just dissapeares. When we disable on cisco interface in vlan 5 - mac address from vlan 50 appeares again.
I'm not sure which diagnostic output should be analized, but "show interface *" doesn't look weird.
Please help!
Thanks in advance.