SRX

Hi everybody,

I wonder is it possible to setup dot1q-tunneling on SRX 210, Junos ver. 10.4.

regards,

Vadim

Hi,

As per the link

http://www.juniper.net/techpubs/en_US/junos10.1/information-products/topic-collections/release-notes/10.1/topic-42298.html

Layer 2 Q-in-Q tunneling on SRX210 is supported from Junos 10.1 onwards. 

Thanks

pradeep

It seems does not work ))). I tried once and no luck.

Could you please post your setup and config details ( that you have tested) , if possible ?

well,

Service vlan 200 in Trust Zone (interface fe-0/0/7, in trust zone)

under vlan configuration the statement dot1q-tunneling  is created

Other interfaces in default vlan 1 - in Trust Zone

Policies: from zone trust to zone trust - permit (all services)

Juniper docs insist that all interfaces in access mode are mapped to Service vlan (in my case in vlan 200)

but nothing  happens like this....

 I tried to turn the device to transparent mode and activate bridge domains, created rewrite vlans but no luck also.

 In this case on trunk interface I have the following: from-vlan-id should not be present in any vlan-id-list on this interface.
error: configuration check-out failed

regards,

Hi,

I have setup a lab as per below and its working fine for me

http://www.junosnotes.in/home/dot1q-tunneling

and for transparent mode vlan re-writing, please check

http://www.junosnotes.in/home/transparent-mode-vlan-rewrite

Hope this helps !