11-07-2011 10:42 AM
Hello to all,
I have two uplinks via ethernet,
One on Fiber optic converter
How to make One - primary uplink
And if traffic not pass first uplinks - flow trafficevia second uplink.
Two different providers which not want to setup any of routing protocols with fault detection.
Thanks A lot Yuriy.
11-08-2011 01:41 AM
Have a look at using qualified next hops with a probe to the default gateway and a script to increase the metric on the 2nd link in the event of a failure.
This has been talked about before:
12-07-2011 05:06 AM
This Solution not full.
One person advice to delete next-hop
Second advice increase metric.
But no solution for return to default state.
I am new in JunOS, where I can find some examples for my case without change Firmware to 11.x
12-07-2011 05:09 AM
You can even load balance the traffic between these two links, for more efficiency, by using Filter Based Forwarding (FBF).
No, it's not acceptable because we have a huge amount of TCP sessions which we want to save.
If I will use two links simuatiosly - I increase posibility of disconnection.