SRX

Hi Folks,

I have doubt regarding our proposed design for the new site in LasVegas, USA. We are designed the setup using SRX5400 for the site failover. One SRX box will be in primary site & another will be in secondary site which will be our DR facility, will setup cluster between these two (fiber connectivity for the HA). I would like to know if this kind of design is supported by Juniper or what will be the challenges & recommendations?

I attached logical design to understand the concept.

Thanks,

G.

http://kb.juniper.net/library/CUSTOMERSERVICE/GLOBAL_JTAC/technotes/3500165-EN.pdf

Thank you!

Hello ,

This setup is supported as per Juniper to have redundant device on different sites . To give a brief heads up :

> The control and the FAb link will be connected using L2 device as per this setup . So you need to enable Jumbo frames on the connected switch to have then UP .

>  A fiber connection is required for the Control Link  between the nodes .

Rest everything follows the same way and the above document will give you a detailed information .

Appreciate..

Thanks much!