Hello all,
I'm familiar using ScreenOS on SSG before but now am new into Junos (SRX) which I have to do some familiarization. I need some advices on OSPF routing troubleshooting via IPSEC tunnel. Am working on a lab set up using multipoint VPN tunnelling. My lab set up is shown in the diagram including two SRX configuration as attached with this message. A few problem that I encountered as follow;
i. OSPF routing via IPSEC tunnel is working but not all routing from both sides are in.
ii. My laptop (with the IP address: 10.88.2.2/24) unable to 'ping' to another laptop (10.45.2.4/24) on the other segment and vice versa.
iii. Both L3 switches are running using OSPF routing and it works fine.
iv. Am unable to 'ping' tunnel interface on the other firewall down to each interface connected to the other firewall.
From here my conclusion is: It might something to do with security policies. Am new to this and I don't know what else I should looking into to solve this problem.
I hope anyone of you with good experience of OSPF routing via IPSEC tunnel could advise and share your knowlegde with me.
Thank you very much for your advice 😄
Alex