SRX Services Gateway
Reply
Visitor
bjackson
Posts: 1
Registered: ‎07-02-2009
0

SRX210 dual homed

I have an SRX 210 with 2 interfaces configured as DHCP clients connected to separate internet circuits. Problem is I do not see the default gateways in the routing table, and all traffic is going out a single interface. Any ideas on how to load balance this traffic? Does not have to be perfect, just need to utilize both circuits.
Distinguished Expert
Screenie
Posts: 1,076
Registered: ‎01-10-2008
0

Re: SRX210 dual homed

You'll have to enable ECMP someware I supose. Might give Natting problems though. Can't rember exactly how to enable this. I believe in a policy between RE and FE. Try a query on ECMP on the KB!
best regards,

Screenie.
Juniper Ambassador,
JNCIA IDP AC WX JNCIS FW SSL JNCIP SEC ENT SP JNCI

If this worked for you please flag my post as an "Accepted Solution" so others can benefit. A kudo would be cool if you think I earned it.
Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.