SRX Services Gateway
Reply
Visitor
ssmith
Posts: 4
Registered: ‎06-07-2012
0
Accepted Solution

Selective ike debug SRX5800

Hi,

Is the command "request security ike debug-enable local <x.x.x.x> remote <x.x.x.x> level 15" effectively working?

If my understanding is correct this should be an alternative to traceoption configuration which is enable globally in the config, but I'm not able to get any input when I issue that. The kmd file (that is supposed to be the default file name for the debug output) does not show anything despite the lvevel 15. Is there any other way to selective debug two ike peers? I'm desperately looking for a way to do so as I've several VPNs and I need to look at a specific site.

 

Thanks,

/S.

Visitor
ssmith
Posts: 4
Registered: ‎06-07-2012
0

Re: Selective ike debug SRX5800

Well,

I haven't got the feedback I hoped here but I've got a solution anyway in case anybody is interested. The procedure for HighEnd series is here (partner access only):

 

http://kb.juniper.net/InfoCenter/index?page=content&id=KB19943

 

Thanks

/S

Trusted Expert
SSHSSH
Posts: 601
Registered: ‎11-21-2009
0

Re: Selective ike debug SRX5800

Hi , i cannot access it even with Partner access , Can you paste its contents 

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.