SRX

hello,

Please help, i have got u-boot failed for SRX240H after power off. i connected with serial cable and error messag are as below;

U-Boot 1.1.6-JNPR-1.7 (Build time: May 4 2010 - 06:59:58)

SRX_240_HIGHMEM board revision major:1, minor:42, serial #: AABP2741
OCTEON CN5230R-SCP pass 2.0, Core clock: 600 MHz, DDR clock: 333 MHz (666 Mhz data rate)
DRAM: 1024 MB
Starting Memory POST...
Checking datalines... OK
Checking address lines... OK
Checking 512K memory for U-Boot... Memory error at 80000184, wrote aaaaaaaa, read aafbaaaa !
Failed!
Memory POST Failed!

tks

HI,

I would suggest first trying to recover the Uboot to see if that helps, if this is not helping and the device is under support

I suggest opening a JTAC Case

http://kb.juniper.net/InfoCenter/index?page=content&id=KB14175&smlogin=true

From the loader (you need to interupt this process)

If you press the space bar as it is booting and interrupt the boot, then you should be able to recover it

set netmask=255.255.255.0
set ipaddr=192.168.253.77
set gatewayip=192.168.253.254
set serverip=192.168.253.220
install tftp://192.168.253.220/junos-srxsme-12.1R2.9-domestic.tgz

Changing the details to match your software version and network

hello,

i hit spacebar serval time when booting but same error message as below;

U-Boot 1.1.6-JNPR-1.7 (Build time: May 4 2010 - 06:59:58)

SRX_240_HIGHMEM board revision major:1, minor:42, serial #: AABP2741
OCTEON CN5230R-SCP pass 2.0, Core clock: 600 MHz, DDR clock: 333 MHz (666 Mhz data rate)
DRAM: 1024 MB
Starting Memory POST...
Checking datalines... OK
Checking address lines... OK
Checking 512K memory for U-Boot... Memory error at 80000184, wrote aaaaaaaa, read aafbaaaa !
Failed!
Memory POST Failed!

appreciated too.

This looks like flash corruption issue and you may need an RMA. Please open a case with JTAC .

http://forums.juniper.net/t5/SRX-Services-Gateway/Unable-Load-JUNOS/td-p/39178

As suggested by some, open a JTAC case

https://casemanager.juniper.net/casemanager/#/create