SRX Services Gateway
Reply
Trusted Contributor
groque1
Posts: 254
Registered: ‎09-09-2009
0

clearing a destination on the forwarding-table

hey guys, 

 

i can't access my WAN IP when I am on my local network.

 

for example: my local IP is 192.168.1.0/24 and my WAN IP is 1.1.1.1. I can't HTTPS or SSH to 1.1.1.1 on my local network (192.168.1.0) but when I am at home I can HTTPS and SSH to 1.1.1.1.

 

My guess is that my destination to 1.1.1.1 is causing problems. I would  like to clear this route on my forwarding-table and try it again. It worked for me last time. 

 

But my question is my network is live at the moment if I clear this out would it mess anything up? 

 

 

Super Contributor
Cesar
Posts: 141
Registered: ‎11-18-2008
0

Re: clearing a destination on the forwarding-table

Have you configured a policy to allow traffic?

Trusted Contributor
groque1
Posts: 254
Registered: ‎09-09-2009
0

Re: clearing a destination on the forwarding-table

Yes I did, I permitted HTTPS SSH and IKE services on my untrust zone and assigned that specific interface ge-0/0/11 (facing WAN) to that zone. Am I doing this correctly. 

 

From the outside of my network I can https, ping etc but from the inside I can't HTTPS or ping my WAN IP

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.