gre tunnel keepalive

[lanzailan]

Hi guys,

How do i configure keepalive and hold time for gr interface on srx?

thanks

[Visitor]

Hi ,

This feautre is not supported on SRX platforms.

Hope this helps.

Regards,

Visitor

-------------------------------------------------------------------------------------------------------

If this post was helpful, please mark this post as an "Accepted Solution".Kudos are always appreciated!

[lanzailan]

Thanks for the reply.

My further question, is it possible to configure only one side?.. let say I have MX at the other end.

[vencour]

Nevermind ... you may try this with linux peer ... for example

# ip tunn help
Usage: ip tunnel { add | change | del | show | prl | 6rd } [ NAME ]
          [ mode { ipip | gre | sit | isatap } ] [ remote ADDR ] [ local ADDR ]
          [ [i|o]seq ] [ [i|o]key KEY ] [ [i|o]csum ]
          [ prl-default ADDR ] [ prl-nodefault ADDR ] [ prl-delete ADDR ]
          [ 6rd-prefix ADDR ] [ 6rd-relay_prefix ADDR ] [ 6rd-reset ]
          [ ttl TTL ] [ tos TOS ] [ [no]pmtudisc ] [ dev PHYS_DEV ]

Where: NAME := STRING
       ADDR := { IP_ADDRESS | any }
       TOS  := { NUMBER | inherit }
       TTL  := { 1..255 | inherit }
       KEY  := { DOTTED_QUAD | NUMBER }

[rgarazd]

Please tell me how to configure the following scheme (SRX 650 ):

which protocol I can use instead OAM? 

Thank you!