I am in the process of setting up my first Juniper device, a SRX 100H2 and the Dynamic VPN is giving me some problems. I just need a very basic IPSec vpn so I followed the wizard, but when I navigate to https://PublicAddress/dynamic-vpn I am getting a 404.
My configuration is rather simple, I have fe 0/0 configured to face the internet zone and it has two IP blocks associated with it. A /30 block for basic internal web traffic and a seperate /29 block which is used to host a couple web and mail servers. The /29 block has a few IP addresses Setup with Static NAT, but it also has 2 unused addresses. I have tried accessing /dynamic-vpn from using IP addresses in both blocks but I still haven’t had any luck.
I have tried looking though the SRX Getting Started - Configure Dynamic VPN (VPN Client) and the dynamic-vpn-appnote-junos10.4-v21.pdf but I am not having much luck.
Thanks for the help