SRX

hello guys, how to reboot SRX 240 from command line?

 

Is there a way to reboot device from web gui?

 

Thank you.

Hi,

 

Please refer to these links:

 

https://www.juniper.net/techpubs/en_US/junos/topics/topic-map/security-restarting-rebooting-and-halting-srx-devices.html

http://www.juniper.net/documentation/en_US/junos12.1x47/topics/example/security-device-srx-series-device-rebooting.html

 

Hope this helps:

 

Thanks

---------------------------------------------------------------------------------------------------------
If this post was helpful, please mark this post as an "Accepted Solution".
Kudos are always appreciated!
----------------------------------------------------------------------------------------------------------

From CLI:

 

root> request system reboot ? ---> You have below options
Possible completions:
  <[Enter]>            Execute this command
  at                   Time at which to perform the operation
  in                   Number of minutes to delay before operation
  media                Boot media for next boot
  message              Message to display to all users
  |                    Pipe through a command
root> request system reboot    
Reboot the system ? [yes,no] (no) yes

 

 

From J-web, go to "Maintain" tab and click on reboot (PFA.. for details).

Thank you all.

 

Thank you rsuraj.

 

Just one quick question, I notice that  J-Web and SSH login is block. I'm not able to access, if I will not login let's say for 2 months.

 

Is this nornal? Or I need to configure something. Thanks again.

 

Just one quick question, I notice that J-Web and SSH login is block. I'm not able to access, if I will not login let's say for 2 months.

Is this nornal? Or I need to configure something. Thanks again.

No, it's not expected. Please check and confirm the config is still active using "show system services" from configure mode.

Hi rsuraj,

 

I went to the config mode and issued the command you've mentioned, "show system services".

 

Yes, I'm able to see the configuration. So, I'm really stumped why this keeps happening.

 

The only way that I can get back or access the J-Web and access SSH is to forcefully shutdown the device.

 

Any ideas, how to solve this issue?

 

Or a firmware upgrade is necessary?

 

Thank you.

Perhaps the brute force login attempt check is enabled.  If so, the lockout is because outsiders are trying to access the SRX.  Be sure to have the appropriate restrictions to prevent access on the WAN port or lock it down to only trusted ip ranges.

 

https://kb.juniper.net/InfoCenter/index?page=content&id=KB28968