11-17-2008 12:09 AM
11-17-2008 04:42 PM - edited 11-17-2008 04:54 PM
From what I have gathered from this incredibly long thread is that you are trying to use the physical interface (which cannot be tagged) and sub-interfaces (which can be tagged). I'm going to talk Foundry since that's the evil I know. On a Foundry, there is what is called dual-mode. On the physical interface of the switch, you configure it for dual-mode, and tell the interface for what default VLAN you want untagged traffic dropped into. All other traffic will be tagged (802.1q) and will be dropped into the proper VLAN.
int e 1
tag e 1
tag e 1
untag e 1
Someone in the world of Crisco, can you confirm what I'm saying:
If a dot1q trunk receives a tagged frame on the native vlan, it drops it.
When a cisco trunk port receives untagged frames it forwards them to the native vlan #1 by default
So, if you want the native VLAN to be something other than 1, you can change the default VLAN, but this does not move STP or other Crisco things from VLAN 1.
11-18-2008 06:35 AM - edited 11-18-2008 06:41 AM
That is correct. I use this configuration on Catalysts, and all untagged traffic leaving the SA is put on the default VLAN on the turnk port of the switch.
Don't know if this suggestion will be useful, but I had some success getting Juniper to move on a "working as designed" issue that I had. I told them - through the JTAC engineer and my local SE - that if it was "working as designed", then it was "designed as stupid". I think that applies here too. If a role has its traffic assigned to a VLAN, and uses DHCP, it makes no sense to send the DHCP request out as untagged traffic. Or - at the least - you should have the option for the DHCP traffic to be sent on the VLAN.
11-18-2008 07:42 AM
OK, so what I said was accurate then. It will send it to the default VLAN. The default VLAN on Crisco can be changed, but that doesn't move things like STP or Crisco proprietary stuff over, that still remains on VLAN 1.