06-13-2012 02:29 AM
I have difficulty in configuring VLAN on my ssg20. I've try to search in KB but failed to get a better reference guide. I hope with this post, all the juniper expert can give advice and share some knowledge and give a futher reference to others
My situation is like this,
I have one dynamic IP that connected to my ssg20 at eth0 (untrust-zone). For eth2 and eth 3, i plan to set the VLAN to this interfaces. I have a server with two different network card. Both have different IP
For eth2 i plan to connect this interface to my server with IP,
I want both network card can route to internet cloud using same gateway. How can i configure this VLAN?
Thanks is advance
Attached is the example network diagram
06-13-2012 05:10 AM
06-13-2012 06:34 AM
06-14-2012 02:35 AM
Thanks for your reply. Much appreciate
The reason why i want to use VLAN is due to my server have two different network card with different gateway 10.0.7.1/24 and 10.0.8.1/24. Both of the network card must be route to internet. But i realized that i also can use two bgroup with different gateway and route using same network
Am i right?
bgroup1 - consist of eth0/2 with IP 10.0.7.1
bgroup2 - consist of eth0/3 with IP 10.0.8.1
06-14-2012 08:12 AM
Connect eth2 and eth3 of the firewall to a switch and both server cards to the same switch. That's it.
You can also configure two VLANs on the switch with two ports in each VLAN. VLAN10: eth2 and NIC1, VLAN20:eth3 and NIC2. No VLANs are required on the firewall also in this case.