Screen OS

Q  : set int vlan1 manage ; what does this command mean?..

+plus

I have lots of Juniper devices..

But I am beginner, so I found Juniper Manual,

During setting the device, I figure out I don't know about Juniper too much.

So main question is that I want to get a specific manual. such as URL

For example,

set int vlan1 manage : [explanation]

HI,

The set int vlan1 manage is for enabling services on that interface to mange the device

example :   set int vlan1 manage ssh

                     set int vlan1 manage ping

See the KB below that explains it.

http://kb.juniper.net/InfoCenter/index?page=content&id=KB9033&smlogin=true

Whichkind of Juniper devices do you have ? Their are a lot of different devices and some are running an other OS then Junos. To give you some hands, it would be handy to know what kind of devices you have.

Ah thank you.!

I have Juniper Firewall, ISG-1000, 2000, SSG-140, NS-25, 50, SSG-520,520M, 550, 550M 

plz contact me:)

Regards,

Hi,

here some basic setup guide

https://www.corelan.be/index.php/2008/06/22/juniper-firewall-screenos-basics-cjfv/

if you need anything just use the forum, a lot have been done already by others, the forum contains a lot of examples and explains about how stuff is working on a ScreenOS device

You can also search in the Juniper Knowledge base

http://kb.juniper.net/InfoCenter/index?page=home

Hope this helps a bit

I see 🙂 

Thanks to U, I can deal with it!

Since you are new to ScreenOS you may find my series of YouTube videos helpful.  I have a 13 series introduction to ScreenOS posted as a playlist here.  the topics are labeld for each module so you can easily skip around as needed.

https://www.youtube.com/watch?v=yZa263pm2a4&list=PL9B6F69E0FE662EB0

On my free Moodle course version I have handouts and supplementary material posted.  You can choose guest to get past the moodle login.  A login is only required if you want to take the quizes at the end of each lesson.  

http://puluka.com/classes/course/view.php?id=5

Ah I know your youtube lecture:)

Thanks!

Also, you can use the help function in the WebUI (? in the upper right corner of each section of the webui).  There is also the Concepts and Examples and the Command Reference Guide.

https://www.juniper.net/techpubs/software/screenos/screenos6.3.0/630_ce_all.pdf

https://www.juniper.net/techpubs/software/screenos/screenos6.3.0/630_ipv4_cli.pdf

You can also use the Juniper videos located at https://www.youtube.com/user/JuniperNetworks/playlists?shelf_id=10&view=50&sort=dd

Thank you rseibert ^^!

so helpful 🙂