I've run into a problem and would like to query the forum about a possible work around or configuration correction.
When using the above specs, the DHCP configuration becomes unavailable after initial configuration. In the web interface the "edit" option shows up as available but when any change is made you receive an error indicating that the "DHCP" variable is not valid.
On the CLI when I attempt a command such as "set interface eth1.1 dhcp server enable" the output indicates that the "DHCP" variable is not recognized.
When the same command is executed without using sub-interfaces, the configuation is accepted.Example, "set interface eth1 dhcp server enable"
The goal of this configuration was to have multiple VLANs handled by the firewall and served DHCP over a single physical interface.
Thank you.
#5.4#screenos#netscreen#25#NS25