Hi.
I have router SSG5.
ssg5-serial-> get system
Product Name: SSG5-Serial
Serial Number: 0162122008004800, Control Number: 00000000
Hardware Version: 0710(0)-(00), FPGA checksum: 00000000, VLAN1 IP (0.0.0.0)
Flash Type: Samsung
Software Version: 6.2.0r5.0, Type: Firewall+VPN
I am trying configure (uses web gui) Traffic Shaping on IP - but it is not work.
ssg5-serial-> get policy id 143
name:"none" (id 143), zone Trust -> Untrust,action Permit, status "enabled"
src "192.168.10.19/32", dst "Any", serv "ANY"
Rules on this VPN policy: 0
nat off, Web filtering : disabled
vpn unknown vpn, policy flag 00004000, session backup: on, idle reset: on
traffic shaping on, scheduler n/a, serv flag 00
log no, log count 0, alert no, counter no(0) byte rate(sec/min) 0/0
total octets 0, counter(session/packet/octet) 0/0/0
priority 7, diffserv marking On
tadapter: state on, gbw/mbw 500/500 policing (no)
No Authentication
No User, User Group or Group expression set
For configure using this documentation:
http://www.juniper.net/techpubs/software/screenos/screenos6.2.0/ce_v2.pdf
what am I doing wrong?
Thank you.
