Hi there
Im trying to set up a site-to-site VPN according to the Juniper's and Fortinet's IPSec VPN guides.
Checking the logs and webUI on both sides looks like the tunnel is up.
Juniper shows that the SA status is active, link is "-" (vpn monitoring is off)
Fortinet is shows in the IPsec monitor that traffic is going out, but nothing is comming in.
I'm unable to ping a host behind the Fortigate.
That's the setup:
Site A: Fortigate SubnetA
Site B: Juniper SubnetB
My routing looks like this:
Site A:
Destination: Subnet B
Device: VPN_Phase 1
Gateway: EMPTY
Site B:
Destination: Subnet A
Interface: tunnel.1
Gateway: EMPTY
Policies are configured on both sides in both directions.
Any ideas or tips where to start from?
Thanks in advance....