ScreenOS Firewalls (NOT SRX)
Reply
Contributor
alex.simbun
Posts: 20
Registered: ‎01-30-2011
0
Accepted Solution

VPN tunnel does not work when multiple dialup vpn (with different user) trying to connect.

Hi,

 

I'm using Shrew VPN client to connect to our Juniper SSG 140 vpn/firewall and had configured both based on step-by-step guide from Shrew (http://www.shrew.net/support/wiki/HowtoJuniperSsg). However, this is only work only for single dialup VPN session. When another dialup vpn (using Shrew VPN client as well) trying to connect to our Juniper SSG140, the current dialup VPN session disconnected and the VPN session is taken over.

 

How to let multiple dialup vpn session to work?

 

Thank you very much!

 

Regards,

 

Alex

Recognized Expert
Sahota
Posts: 484
Registered: ‎03-15-2012
0

Re: VPN tunnel does not work when multiple dialup vpn (with different user) trying to connect.

Hi Alex,

 

Did you try the following:

 

http://kb.juniper.net/KB14883

 

Hope this helps.

 

Regards.

Hardeep

Contributor
alex.simbun
Posts: 20
Registered: ‎01-30-2011
0

Re: VPN tunnel does not work when multiple dialup vpn (with different user) trying to connect.

Yes. I did and it works fine now. I found out that I have to increase the number of multiple login with same ID.

 

Thank you very much! :smileyhappy:

 

Alex

Recognized Expert
Sahota
Posts: 484
Registered: ‎03-15-2012
0

Re: VPN tunnel does not work when multiple dialup vpn (with different user) trying to connect.

Hi Alex,

 

Good to know that link was helpful.

Can you please mark this thread as resolved so that others cvan benefit from it.

 

Regards.

Hardeep

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.