hi there,
im having trouble connecting to the WebUI of my netscreen 25 and im wondering if you can help me. below is the config of interface1 which is where i usually manage the firewall from, it looks like webui is enabled but webauth is disbaled - is this what could be stopping me connect??. what is the command through the console to enable this if it is?
thanks for your help
lonns25-> get int eth1
Interface ethernet1:
description ethernet1
number 0, if_info 0, if_index 0, mode nat
link up, phy-link up/full-duplex
vsys Root, zone Trust, vr trust-vr
dhcp client disabled
PPPoE disabled
admin mtu 0, operating mtu 1500, default mtu 1500
*ip 172.16.23.10/23 mac 0010.db19.5730
*manage ip 172.16.23.10, mac 0010.db19.5730
route-deny disable
pmtu-v4 disabled
ping enabled, telnet enabled, SSH enabled, SNMP enabled
web enabled, ident-reset disabled, SSL enabled
DNS Proxy disabled, webauth disabled, webauth-ip 0.0.0.0
OSPF disabled BGP disabled RIP disabled RIPng disabled mtrace disabled
PIM: not configured IGMP not configured
bandwidth: physical 100000kbps, configured egress [gbw 0kbps mbw 0kbps]
configured ingress mbw 0kbps, current bw 331kbps
total allocated gbw 0kbps
DHCP-Relay disabled
DHCP-server disabled
Number of SW session: 31780, hw sess err cnt 0
lonns25-> get admin
HTTP Port: 80, HTTPS Port: 443
TELNET Port: 23, SSH Port: 22
Mng Host IP: 206.186.240.190/255.255.255.255
Mail Alert: On, Mail Server: exch01.domain.com
E-Mail Address: will.gerrish@domain.com
E-Mail Traffic Log: Off
Configuration Format: DOS
Device Reset: Enabled
Hardware Reset: Enabled
Admin privilege: read-write (Remote admin has read-write privileges)
Max Failed Admin login attempts: 3
HTTP redirect: false