cannot connect via WebUI

[wgerrish]

the screen OS i use is 5.4.0r6.0

also what command is needed to change the Mng Host IP? cant seem to find it in any of the forums...

thanks again EL

[wgerrish]

Hi EL,

i found this command but it only seems to work in the earlier version of the OS

set admin sys-ip "0.0.0.0"

Set adm sys-ip has been obsoleted since 4.0

the OS im currently running is  5.4.0r6.0 

thanks again

Will 

[ELKIM]

hi

Please review this command

mng-ip <a.b.c.d>
[<A.B.C.D>]

The IP address for the remote system you use to log in,
configure, and manage the NetScreen device. The
<a.b.c.d> represents the IP address, and the <A.B.C.D>
represents the subnet. The default is 0.0.0.0, which allows
management from any station. NetScreen-5 allows you to
specify up to 6 hosts or subnet masks, one at a time. All
other devices allow one.

mng-ip {<a.b.c.d> | <all>}

When using unset, specifies one or all of the six possible
management IP addresses for the NetScreen-5.

[ELKIM]

Hi

Could you PM your config ?

thanks

EL

[wgerrish]

done

[ELKIM · Accepted solution]

HI

U can do this command

unset admin manager-ip all

i hope this work for you

Thanks

EL

[wgerrish]

this worked.

thanks so much