ScreenOS Firewalls (NOT SRX)
Reply
Visitor
trfunite
Posts: 3
Registered: ‎11-08-2010
0

configure SSG20 to run IPSEC VPN using ADSL

[ Edited ]

Hi All,

            Recently i've been task to configure site to site IPSEC VPN tunneling using ADSL on devise SSG20 on one end and SSG320 with static ip address on the other end, could someone please advise me if this can be done and if possible where can i find documents pertaining to this configuration as well as the firmware and hardware requirement? Thanks a lot in advance.

 

Regards,

Malcum 

Distinguished Expert
spuluka
Posts: 2,691
Registered: ‎03-30-2009
0

Re: configure SSG20 to run IPSEC VPN using ADSL

I assume the issue is that your adsl side does not have a static ip address.

 

If that is the case, then kb15075 has the procedure outlined for you.  This will create a site-to-site route based vpn where one side is static and the other dynamic.

 

http://kb.juniper.net/InfoCenter/index?page=content&id=KB15075

 

If this is not what you are looking for then you can start with the VPN configuration and Troubleshooting tree and walk down the list to the scenario you have.

 

http://kb.juniper.net/kb/documents/public/resolution_path/J_FW_VPN_Config_or_Trblsh.htm

Steve Puluka BSEET
Juniper Ambassador
Senior Network Engineer - UPMC Pittsburgh, PA
JNCIA-ER JNCIA-EX JNCIS-SEC JNCIP-SEC
JNCIS-FWV JNCIS-SSL
MCP - Managing Server 2003 MCP - Windows XP Professional
MCTS Windows 7
http://puluka.com/home
Visitor
trfunite
Posts: 3
Registered: ‎11-08-2010
0

Re: configure SSG20 to run IPSEC VPN using ADSL

Hi Spuluka,

                      Thats what im looking for. Thanks a lot..

Copyright© 1999-2013 Juniper Networks, Inc. All rights reserved.