Hi All
I am new to juniper so if you can bear with me -
I need to configure a firewall to be in ospf area 0
on both sides - trusted and untrusted.
But to pass throught the relevant protocol info
while still performing the firewall function
I have configured up our ISG1000 so that the
trust and untrust zones are in the relevant vrs and
the relevant vrs are both in the same OSPF area -0
i have put in policy to allow ospf between both areas
and in each direction.
I have enabled ospf on the 2 interfaces.
When i look on the Vr routing page i have a green O
under DRP which seems to indicat that both vrs should
have ospf working.
However it doesnt seem to be allowing ospf to
work from one side of the firewall to another.
While the trust side is working with ospf to a cisco l3
switch.
Can you have both trust and untrust on the same
ospf area ?
Also - on the trust side the ospf is working to a cisco
switch - i reset the router-id but the ISG is still seeing
the old Router-id - how do i get it to see the new
router-id ?
Sorry if these are obvious but my juniper experience is
nil .
Steve