Hi, we are upgrading SSG320M to ISG2000, when I transfered the configuration from SSG320M to ISG2000, I noticed that ISG2000 is using significantly more memory than SSG320M with the same configuratio...
hi iam absolut beginner on this Juniper but this are intress me! yesterday i was update to last Firmware now it's running with 6.2.0r16 :-) with me little network that i run i will configure diffre...
Hi Guys, We just recently noticed that our SSG 5-Serial firewall is using a lot of memory while the other resources are low. Isn’t it should just be the same with the CPU? Any explanation on why th...
Having an issue w/ a new configuration I'm applying to 2 SSG 20s at remote sites. I'm trying to setup ospf to work properly in a broadcast connection. I'm able to ping across from unit1 to unit2 w/...
Hello, everybody. I am new to Juniper so I got a very strange (maybe simple) question. Recently I got a 5xt-105-swift box, I put it back to factory default, and after that, I found some behaviours ...
Hi, I have an interface with a /29, I have a webserver sat on my LAN which can see the internet just fine on the IP address of the interface. I also have policy based NAT to allow ping, http, and...
Hey guys, I am new to netscreen so this question might sound a bit easy but for some reason whenever I move my e0/0 (public IP addr assigned, lets call it 1.1.1.1) to UnTrust, I cannot ping/get HTTP...
Hi All, I've got an SSG140 with two untrust interfaces; a cheap and fast VDSL line and an expensive, reliable but slow (2Mbit) leased line. We use both lines for redundant route-based VPNs; the le...
