Application Acceleration
Highlighted
Application Acceleration

Reconfigure WXC 500 from client mode to registration server mode?

‎08-19-2008 02:25 AM

HI!

  What's about subj, w/o reseting device? Is it possible?

 

thx

4 REPLIES 4
Highlighted
Application Acceleration

Re: Reconfigure WXC 500 from client mode to registration server mode?

[ Edited ]
‎08-20-2008 04:30 PM

Hello d00d - not sure what your question is. Are you asking how to transfer registration server duties from one WX box another? That is done by going to the Device setup tab, selecting Registration server and then selecting the transfer option. No reboot is necessary.

 

Note however that you must also manually redirect the other WX devices to point to that server if transfering like this.

 

If that is not what you are asking then please clarify for assistance.

 

 

Message Edited by muttbarker on 08-20-2008 04:31 PM
Kevin Barker
JNCIP-SEC
JNCIS-ENT, FWV, SSL, WLAN
JNCIA-ER, EX, IDP, UAC, WX
Juniper Networks Certified Instructor
Juniper Networks Ambassador

Juniper Elite Reseller
J-Partner Service Specialist - Implementation

If this worked for you please flag my post as an "Accepted Solution" so others can benefit. A kudo would be cool if you think I earned it.
Highlighted
Application Acceleration

Re: Reconfigure WXC 500 from client mode to registration server mode?

‎08-20-2008 11:04 PM

Here is a scenario:

   I have 5 devices, its all in client mode. I want to reconfigure 1 device from client mode to registration server. I haven't any devices in registration server mode now, so i want to reconfigure 1 device. So it seems i need to reset 1 device and throught the quick setup process configure registration server mode.

Highlighted
Application Acceleration

Re: Reconfigure WXC 500 from client mode to registration server mode?

[ Edited ]
‎08-20-2008 11:57 PM

Hi,

 

You can set a client to a Reg server but you need to do it through the Cli.

 

Have a look in the manual page 338. using the configure reg-server command.

 

configure reg-server

 

set ip-address <ipaddress of the wx you configuring>

 

set password

 

Regards

 

Andy

Message Edited by AndyC on 08-21-2008 12:09 AM
JNCIS-FWV
JNCIA-WX
JNCIA-SSL
JNCIA-ER
Highlighted
Application Acceleration

Re: Reconfigure WXC 500 from client mode to registration server mode?

‎08-24-2008 04:09 PM
It is a 100% requirment that one device is a registration server for a community of WX's to work.
Danny Jump
Technical Marketing Manager - Access and Acceleration Business Unit