Ethernet Switching
Highlighted
Ethernet Switching

Auto Image Upgrade

[ Edited ]
‎09-14-2018 01:28 PM

I completed an update to the firmware to 15.1X53-D59 via usb and now I keep getting recurring message: 

 

Auto Image Upgrade: DHCP Client Bound interfaces:

Auto Image Upgrade: DHCP Client Unbound interfaces:

Auto Image Upgrade: To stop, on CLI apply
"delete chassis auto-image-upgrade" and commit

Auto Image Upgrade: No DHCP Client in bound state, reset all DHCP clients

Auto Image Upgrade: DHCP Client State Reset:

 

I am at this time trying to also update the J-web though the interface and its not accepting the update i beleve it's because of above Any tips would be gratly apprecated. It's a Ex3400 POE

4 REPLIES 4
Highlighted
Ethernet Switching

Re: Auto Image Upgrade

‎09-14-2018 04:59 PM

Just go into the CLI and while the messages are spewing out type:

 

delete chassis auto-image-upgrade

commit

 

and then move forward.

Highlighted
Ethernet Switching

Re: Auto Image Upgrade

‎09-14-2018 06:17 PM

sounds simple enough but i get: 

 

{master:0}[edit]
root@demoroom# delete chassis auto-image-upgrade
delete chassis auto-image-upgrade
warning: statement not found

{master:0}[edit]
root@demoroom#

 

or : 

unknown command.
root@demoroom> deletechassisauto-image-upgrade
^
unknown command.

{master:0}
root@demoroom>

 

Highlighted
Ethernet Switching

Re: Auto Image Upgrade

‎09-17-2018 04:45 AM

I was able to get rid of this finally but it seem to go away after I finished the ezsetup only. thenks for your  help. 

Highlighted
Ethernet Switching

Re: Auto Image Upgrade

‎11-05-2018 05:49 AM

I am getting the same errors, however, I cannot seem to do the EZSetup either. I am getting a "Command Not Found" each time.

Feedback