Hello,
I would like to know if it is possible to change the POE Mode on my juniper switch EX2300-48P from 802.3at to 802.3af. I am trying to configure an access point which supports only 802.3af.
From what i have searched, 802.3at covers 802.3af. But I don't see any thing on the port or APoint.
Here are a few details if that might help:
admin@sw-jun-poc-2> show poe interface ge-0/0/6
PoE interface status:
PoE interface : ge-0/0/6
Administrative status : Enabled
Operational status : OFF
Operational status detail : Detection In Progress
FourPair status : Disabled
Power limit on the interface : 15.4W
Priority : High
Power consumed : 0.0W
Class of power device : not-applicable
PoE Mode : 802.3at
############################
admin@sw-jun-poc-2> show interfaces ge-0/0/6 brief
Physical interface: ge-0/0/6, Enabled, Physical link is Down
Link-level type: Ethernet, MTU: 1514, LAN-PHY mode, Speed: Auto, Loopback: Disabled, Source filtering: Disabled, Flow control: Disabled, Auto-negotiation: Enabled, Remote fault: Online,
Media type: Copper, IEEE 802.3az Energy Efficient Ethernet: Disabled, Auto-MDIX: Enabled
Device flags : Present Running Down
Interface flags: Hardware-Down SNMP-Traps Internal: 0x4000
Link flags : None
Logical interface ge-0/0/6.0
Flags: Device-Down SNMP-Traps 0x24024000 Encapsulation: Ethernet-Bridge
eth-switch
Thank you. 🙂