Ethernet Switching
Ethernet Switching

EX2300 Configure 1G (RJ45) as VCP

‎08-20-2019 04:26 AM

Hello,

 

Can we configure a 1G (RJ45) interface as Virtual Chassis Port? I was able to configure my virtual chassis using the fibre ports but I want to do same using the 1G ports. Is there anyway possible? So far I found nothing... 

 

Thank you.

 

2 REPLIES 2
Ethernet Switching
Solution
Accepted by topic author noc@linkbynet.com
‎08-20-2019 11:19 PM

Re: EX2300 Configure 1G (RJ45) as VCP

‎08-20-2019 05:02 AM

Hi,

 

On a EX2300 device, you cannot use 1G ports to form a Virtual Chassis. EX2300 switches do not have dedicated VCP ports and so you only have to use the 10G Uplink ports by converting them into VCP. Now these 10G uplink ports support SFP and SFP+ transceivers as well but only SFP+ transceivers are to be used for Virtual Chassis VCP ports.

 

However, on a EX2200 device, you can use 1Gig ports as VCP to form Virtual Chassis. You can bundle a max of 8 1Gig ports to form a LAG which acts as a VCP.

 

Reference: https://www.juniper.net/documentation/en_US/junos/topics/concept/virtual-chassis-ex4200-overview.htm...

 

I hope this helps.

 

Thanks,
Pradeep
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too!!!

Ethernet Switching

Re: EX2300 Configure 1G (RJ45) as VCP

‎08-20-2019 05:34 AM

No, only the uplink ports can be used for VCPs.

 

Cabling requirements for Virtual Chassis—You can interconnect EX2300 switches into a Virtual Chassis by using the uplink ports configured as Virtual Chassis ports (VCPs).

 

https://www.juniper.net/documentation/en_US/release-independent/junos/topics/topic-map/ex2300-virtua...