How to add banner in Juniper 2200 switch.
I have tried below commands but it is not working.
set system login messege < messege>
but after adding banner only one word is displayed .
Go to Solution.
can you show full command and the banner displayed ?
Just tested on EX2200 running 10.4.R9.2, no problem seen:
admin@EX2200# set system login message "----------\nIt's a banner\n2nd line\n----------\n"
It's a banner
Another example at http://www.dummies.com/how-to/content/how-to-configure-a-login-banner-on-junos-devices.html
Thanks JTB Its working
Why does the example in this link not use the backslash as shown in Juniper's documentation?
I ask because my SRX is ignoring the new lines I'm specifying.