Ethernet Switching
Ethernet Switching

In log, command the is not showing, which is run by network admin in ex4200 switch.

[ Edited ]
‎10-18-2019 09:29 AM

Dear Team,

 

In log, command is not showing, which is run by network admin in ex4200 switch.

i have use below command to check the logs.

 

show log audit

show log interactive-commands

show log messages

 

Thanks & Regards..

Umesh Sharma | +91 9007743324 

JNCIA | JNCIS 

3 REPLIES 3
Ethernet Switching

Re: In log, command the is not showing, which is run by network admin in ex4200 switch.

‎10-18-2019 11:19 AM

Hi bnrumesh,

 

  "show cli history" and "show log interactive-commands" track commands used by users. Which command were you trying to check?

Ethernet Switching

Re: In log, command the is not showing, which is run by network admin in ex4200 switch.

‎10-20-2019 05:20 AM

Can you share the syslog configuration?

 

>show configuration system syslog

Ethernet Switching

Re: In log, command the is not showing, which is run by network admin in ex4200 switch.

‎10-20-2019 05:20 PM

Assuming you are looking for logs of commands run by users then

show log interactive-commands

Would be the correct one assuming you have this in your configuration

system syslog {

file interactive-commands {
    interactive-commands any;

 

Note that the local file does roll over for size but will save several local copies so using the ? prompt you can see how many files are there and then look in older files which add a period number to the file name

show log interactive-commands?

interactive-commands

interactive-commands.0.gz

interactive-commands.1.gz

 

 

 

Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home